Description

1 x BuildTak build surface

8″ x 8″ 203mm x 203mm

Good for standard 20 x 20 cm beds

0.015 inches thick.. (0.381mm)

Please look online for instruction on bed levelling and installation… prints adhere to this material exceptionally well.. if your z offset is not correct.. you may have trouble removing the print from the BuildTak and cause damage to it.

White

Sheets can be cut to size… to suit your print bed

Ideal build surface for FFF 3D printers

Key Features:

• Works with PLA, ABS, HIPS, PET+, Brick, Wood & Flexible (TPE) filaments; additionally we have had success with getting nylon and t-glase (PETT) to adhere when used with a thin layer of washable glue stick on the BuildTak surface. (For printing with PETG, refer to our BuildTak PEI surface.)
• Installs much easier than masking tape or films typically used and with fewer chances of air bubbles
• Protects build plate
• Heat resistant and durable, can be reused for many consecutive builds and you can use different filament materials without the need to change the printing surface
• Creates an optimal bond between the 3D printed object and build surface that maximizes the chances your object will be held in place for the duration of the print and then allow for clean and easy removal of the object from the build surface.

All Stock located in Melbourne, Australia